586,076 active members*
3,984 visitors online*
Register for free
Login

Thread: Parameter change

Results 1 to 2 of 2
  1. 05-28-2008, 03:33 PM #1
    adamant
    adamant is offline Registered
    Join Date
    Nov 2004
    Posts
    110

    Parameter change

    Howdy folks.

    I'm working on a hardinge conquest t42 with an 0-T control. The CSS seems to have been turned off.

    I don't have the manual...........
    I got some advice that param 902 #2 was the one for CSS.

    If I remember right the bits are counted from right to left?

    Thanks.

    Adamant
    Reply With Quote Reply With Quote
  2. 05-28-2008, 05:37 PM #2
    viorel26
    viorel26 is offline Registered
    Send a message via Yahoo to viorel26
    Join Date
    Jun 2007
    Posts
    119

    Bit

    Bit #7 #6 #5 #4 #3 #2 #1 #0
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Fanuc 18i optional parameter change
    By jojojoo in forum Fanuc
    Replies: 16
    Last Post: 02-27-2024, 06:52 PM
  2. How to change Tool change position(About MAZATROL T1 control)
    By liushuixingyun in forum Mazak, Mitsubishi, Mazatrol
    Replies: 6
    Last Post: 01-07-2014, 01:33 AM
  3. Parameter to change for barrier control on a T2 lathe
    By nervis1 in forum Mazak, Mitsubishi, Mazatrol
    Replies: 3
    Last Post: 08-28-2008, 09:16 AM
  4. Tool Change Parameter
    By Jason812 in forum Fanuc
    Replies: 3
    Last Post: 11-21-2007, 02:29 AM
  5. 18i hidden parameter view/change?
    By john k in forum Fanuc
    Replies: 6
    Last Post: 12-22-2006, 07:58 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules