586,103 active members*
3,799 visitors online*
Register for free
Login

Thread: Engine Lathe

Results 1 to 3 of 3
  1. 06-01-2008, 04:23 AM #1
    robclemson
    robclemson is offline Registered
    Join Date
    Apr 2008
    Posts
    17

    Question Engine Lathe

    I have a large 1950 Monarch Engine Lathe 15" chuck, 60" turning length that needs some care. I have a quote for the rebuild at about $25K. Should I rebuild or buy new ? If new, which brand would be close in quality and rigidity ?
    Reply With Quote Reply With Quote
  2. 06-01-2008, 09:36 AM #2
    budP
    budP is offline Registered
    Join Date
    May 2008
    Posts
    110
    Hi Rob
    I ran one of these in the mid 50's and they were the cream of the crop at that time.
    I would not rebuild one of them for the following reason's.

    No gears for Metric, I dont know what it weighs but they are really heavy, It takes a ton of motor to run the darn thing. Tool holders are very large and may not even be available.
    One of these sold in Denver at a auction about 6 years ago for $1700.00 with a bunch of extras.

    Good luck.
    Bud
    Reply With Quote Reply With Quote
  3. 06-02-2008, 12:36 AM #3
    robclemson
    robclemson is offline Registered
    Join Date
    Apr 2008
    Posts
    17
    What brand would you suggest for a new engine lathe that might run as well ?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Converting my Engine Lathe to an 8-Station Turret Lathe!
    By widgitmaster in forum Uncategorised MetalWorking Machines
    Replies: 95
    Last Post: 08-09-2018, 04:56 PM
  2. Bridgeport/ROMI Engine lathe
    By smittys800 in forum Bridgeport / Hardinge Mills
    Replies: 19
    Last Post: 04-14-2009, 03:02 PM
  3. Engine Lathe
    By robclemson in forum Uncategorised MetalWorking Machines
    Replies: 0
    Last Post: 06-01-2008, 04:21 AM
  4. Buy used Hardinge toolroom engine lathe
    By Calvin08 in forum Bridgeport / Hardinge Mills
    Replies: 0
    Last Post: 10-15-2007, 01:14 AM
  5. new 14 X 40 engine lathe
    By chip cruncher in forum Uncategorised MetalWorking Machines
    Replies: 3
    Last Post: 09-29-2007, 02:33 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules