I have a osmc board.
I have a ELM-chan board.
How I can connect the 2 signals pwm on OSMC board ?
Because the HIP4081 is not managed like a IR2184 for example!
Thank you for advance
PS : I'm a french guy and i write very bad english ;-)
I have a osmc board.
I have a ELM-chan board.
How I can connect the 2 signals pwm on OSMC board ?
Because the HIP4081 is not managed like a IR2184 for example!
Thank you for advance
PS : I'm a french guy and i write very bad english ;-)
Basically the 2184 turns on the low side fets if no input signal is recieved, in the case of the HIP4081 you have to give the low side an input to turn it on, with the two PWM signal's from the Elm Chan board, take one and connect it to both "B High in" and "A low in", the other PWM signal goes to both "A High in" and "B Low in".
This should work.
Cheers.
Russell.
P.S. I think your English is a lot better than my French
I would test that this week !
Thank you
Stephane