Hello

After some passive use of CNC zone forum
i am having a problem which i cannot solve by myself.
A good reason to step in!

I am currently running my Step4 precise 760 router with mach3.
It was quite easy to get the XYZ Axis working with the Step four SF-C2 controller. but here it comes!
I do also have a SFC-160 spindle controller which connects to the
SF-C2 box with a serial connector.
i cannot figure out how to get the spindle working with Mach3
I,ve found a lot of data on the internet about ports and pins, but
not one file shows the actual signal flow of the SF-C2 controller,
or the pin settings, and signals that are used to steer the spindle.
Does anybody know how to configure this setup?

Best regards
Bram