Is this wiring right?
KL23H286-20-8B
(bipolar parallel)
A BLU/WHT RED/WHT
A- BLU RED
B GRN/WHT BLK/WHT
B- GRN BLK
http://www.kelinginc.net/KL23H286-20-08B.pdf
I wired the drives to the steppers. The red LED by the PWR/Alarm is on now and the steppers are hard to turn by hand.
Also, when configuring in Mach 3, The drive is labeled with:
ENA
PUL
DIR
I figure that DIR and PUL are configured in the motor pins configuration for direction and step. (Are they active low or high?)
I am unsure about ENA though.
Thanks for the help