Trying to figure out sl-10... Only have x and y axis... set my part offsets, enter MDI mode and program X0 Y0 and it sets an alarm off saying "V axis disabled"... I have no v axis. WTF?
Trying to figure out sl-10... Only have x and y axis... set my part offsets, enter MDI mode and program X0 Y0 and it sets an alarm off saying "V axis disabled"... I have no v axis. WTF?
Yes you do....
The V axis is the barfeed.
Look to see if you have it turned on in the parameters and the cable not plugged in....
normaly on lathes you have x and z axis , maybe this is the reason ?