586,080 active members*
3,925 visitors online*
Register for free
Login

Thread: powering up hardinge DV-59

Results 1 to 2 of 2
  1. 06-30-2008, 11:33 PM #1
    logos
    logos is offline Registered
    Join Date
    Jul 2003
    Posts
    51

    powering up hardinge DV-59

    I am about to power up my Hardinge I am using a rotory phase convertor. Does anyone know where the hot leg goes? (Some call it the wild leg)
    Reply With Quote Reply With Quote
  2. 07-07-2008, 01:10 PM #2
    logos
    logos is offline Registered
    Join Date
    Jul 2003
    Posts
    51

    different forum?

    Should I post this in different forum? If so which one.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. powering down the control
    By Joe Miranda in forum Milltronics
    Replies: 3
    Last Post: 04-13-2008, 02:48 AM
  2. Fanuc OT-C Not Powering Up
    By JerryH in forum Fanuc
    Replies: 4
    Last Post: 08-22-2007, 12:34 PM
  3. Input signal fails when powering up drivers.
    By Witsenburg in forum CNC Machine Related Electronics
    Replies: 2
    Last Post: 07-02-2007, 09:02 PM
  4. hardinge ahc
    By Runner4404spd in forum Uncategorised MetalWorking Machines
    Replies: 0
    Last Post: 04-11-2007, 03:10 PM
  5. Transformer on ebay AU for powering CNC
    By Greolt in forum Australia, New Zealand Club House
    Replies: 0
    Last Post: 06-19-2006, 07:54 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules