[bsimages]

I just cut part of the Last Supper with a 1/8" spiral saw bit, with one inch of depth...in one pass!
I told the settings that I was using a 1/8" ball nose, when in fact I was using a spiral saw bit that has a slight V taper on the tip.
What do you think?
Bill

[metalworkz]

Hi Bill,
That sounds pretty impressive in a single pass at 1.0"! Do you think this could be incorporated with other tools to to perhaps rough hog out the majority of the material and do a finish pass with another tool? That's got to be a big time savings compared to other techniques.

[bsimages]

Of course you could but why would you? I did the rough pass and finishing pass in one pass...