I did not manage to get my hands on any probing tonight. The main task has been to make that dust shoe working and my 4th axis.
Attached is pic of the BB which is in the machines "engine compartment". We have also discussed the topic in the main thread where I posted pics of the handheld controller :
http://www.cnczone.com/forums/showth...46637&page=173
Have you run a machine using a crossover cable and a PC through the BB inside the machine? I had a sneaking feeling that this was the way the machines sold using Mach3 was configured but I have not received any feedback on this from the factory.
Thank's a bunch again.
You're help is highly appreciated and I guess a donation is in it's place if this would work out
Regards
Kent