I was under the idea that poeple here were guru's on routers and this software? I went to the guys shop last night and check it out. He has an old router that he runs with gerber and artpath. He has no issues with that. He bought the new machine from China "boo". The machine has mach3 as the controling software and "lazycam" as its processor. His worker had the machine moving around but it was small movements? I looked at the position screen and it appears that it is set for metric. The program he was running was in inches. I have been in contact with artsoft and he gave me som hints on this problem. I will probably have to re-configure it in "imperial". He also sugested getting a better cam program from vectric. I think that I will see if he can change his posted program to matric and test it again?