I am using Solidworks 2005 with the new Indent feature.
I cannot figure out how to use the new feature.
Anybody?
I am using Solidworks 2005 with the new Indent feature.
I cannot figure out how to use the new feature.
Anybody?
Never mind - I figured it out. :banana:
How many changes are there in 2005 compared to 2004? Just curious, I know they haven't changed much in $autocad$ other than internet stuff
2005 changes? Umm...actually too many to list. There is a "What's New?" informative book in PDF with over 200 pages long and I am still learning them.
So tell us how...I was waiting and I got snuffed
I was trying to use it two nights ago, could not figure out what to put in the second box, I clicked on geometry and nothing...
I figured out how to use the Indent feature from the Help menu in SW. Practice is the key.
I heard there are a lot of changes. I have seen some of them but not a lot. I am still waiting for my shop to get 2005.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)