I am running Mach 3 on a CNC Bridgeport. I can run a G code program but I do not have any manual control over any axis. When I tab for Jog Screen I cannot change the increment for the jog or the jog from step.
Any help is appreciated.
Thanks
AJ
I am running Mach 3 on a CNC Bridgeport. I can run a G code program but I do not have any manual control over any axis. When I tab for Jog Screen I cannot change the increment for the jog or the jog from step.
Any help is appreciated.
Thanks
AJ
Check this setting
Blackbeard52
Thanks for the reply--that fixed the problem. Where do I sent the check?
Thanks again,
AJ
WOW...I didnt think it would be that simple... but I usually take that approach...Glad I could help...pass it on
Bob