Originally Posted by
wes4540
Hello everyone, let me just say first off that I this is a great site with a lot of helpful people & information,I hope in the future I am able to help provide solutions to someones problem.
OK, I just purchased my 1st cnc lathe,and I am having problems getting the hydraulics up. I am getting an alarm 02 vrdy off,I am able to reset the alarm for approx.5-10 sec. then it pops back up.I have tried holding the alarm reset button while pushing machine ready and nothing. The lathe sat for about a year with no power and after reading the post's here I am afriad it may have lost its parameters.(I have replaced the battries)It is not near a overtravel on either axis. Would that alarm not allow the hydraulic system to come up? Any help or advice is greatly appreciated.
thanks,Wes