Hi folks,
I have been silently developing a motion controller which plugs into USB and provides 6 SPI channels for VSD drives. It provides far more advanced alternative to step/dir. It finally unleashes the full power of servo drives.
Target specs (may change):
- Update rate 6x2500 Hz
- On-board data buffering to eliminate PC real time requirements
- All kinds of motor/drive feedback data available to control software
- Cost less than a drive
- 6 general purpose I/O or analog inputs
- Open source programming library
- Reduces cable mess
- Possible to tune drives without unplugging any cables or opening cover
- Comes with pre-assembled flat flex cables, just snap them in
It can be used to make point-to-point apps as well as continuous motion tracking (suitable for CNC).
Results 1 to 20 of 71
Threaded View
-
08-05-2008, 04:28 PM #1
Registered
- Join Date
- Sep 2004
- Posts
- 1207
Low cost 6 axis USB motion controller
Reply With QuoteSimilar Threads
-
low cost linear motion with feedback
By eganders in forum Linear and Rotary MotionReplies: 7Last Post: 11-16-2007, 07:04 PM -
Need advice for affordable 3-4 axis motion controller
By mugabe in forum Controller CardsReplies: 2Last Post: 09-29-2007, 11:27 PM -
3-4 axis motion controller
By grebator in forum Stepper Motors / DrivesReplies: 5Last Post: 04-19-2007, 09:15 PM -
PARKER 6K2 or 6K4 Motion controller
By TUCSONCNC in forum Post Processors for MCReplies: 0Last Post: 02-02-2007, 07:07 AM -
The cost of motion
By Jcadwell in forum DIY CNC Router Table MachinesReplies: 11Last Post: 04-22-2004, 02:18 PM
Posting Permissions
