Dear CNC zone partners,
I'm looking for the special settings parameter of a Fanuc controller series OT model D. Somebody could help me with this problem? i had to clear the ram because the machine is disable to make any operation. Thanks
Dear CNC zone partners,
I'm looking for the special settings parameter of a Fanuc controller series OT model D. Somebody could help me with this problem? i had to clear the ram because the machine is disable to make any operation. Thanks
Do you mean the 900 option parameters or the general setup parameters, Both are unique to the machine as set by the MTB, you will either have to contact the MTB or post the make model if you are missing the parameters, in the hope someone has the same machine.
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Thanks Al,
Yes, i'm looking for the 900's parameters. I have a copy of the data sheet where the special parameters are, however much of them are not visible. These are some datas about the controller:
Mark: Daewo Puma 8HC
Model: A02B-0098-B511
Serial Number: 0060550
Regards
the "setting" page key and the "parameter" key take you to different places
Hello everyone, FYI maybe this link could be useful http://cncfanuc.blogspot.com