[quadtard]

I am trying to turn some internal threads (pitch:6, Min id:1.2, Max id:1.325, depth:.55)

I can't use g92, because the leadout is too sharp of an angle and the threads need to come as close to the shoulder as I can get them.
I am not sure what the P value needs to be, anybody able to help get a code for this?

[Geof]

.....I can't use g92, because the leadout is too sharp of an angle and the threads need to come as close to the shoulder as I can get them....

The leadout is not dependent on whether you are using G92 or G76, it is a Setting. I do not remember the Setting number but I think it is called Thread Retract angle or something. You will probably get the same leadout with G76.

[quadtard]

ok, so I just need to find the setting.

[Mr.Xtreme]

Setting # 95, 96
Thread chamfer size
Thread chamfer angle


Paul

[quadtard]

Yep, I found it. It took care of it. Thanks.