Hi,
I have a Leadwell MCV 760 XL Vertical Machining Center with a FANUC 10M control. Recently in some severe weather, we had a power surge that damaged the electronics on 2 machines. The 10M control is still not running.
There is no CRT. I have already replaced the monitor,power supply,pc board, and main pc board. I was getting a b on the main pc board before replacing it, but now I am getting an 8. I have checked the voltage to the pc board and it is at about 4.97V.
I know that the parameters and memory are lost. I have the parameters to reload them, but I am not sure what the 8. alarm means- I do not see it listed in the manual. Is there a procedure that neeeds to be followed in order to get this control to boot up?
aNY HELP WOULD BE greatly APPRECIATED.
THANKS!!
Mike