[ajm100a]

How can I turn on the servo diag page. It is on the soft key menu with parameter and diagnostics. The one that shows the load and percent of current of the specific axis and the axis parameters.
We have other machines with same control that has this function turned on, and this one does not. Is it a parameter or a option??

Thanks in advance...

[RRL]

On the Fanuc 0 the parameter # is 389 bit 0. Change it from 1 to 0 (need to have PWE on). I don't remember if you need to power down and back up again though.

Once you have this enabled BE CAREFUL. Parameters in this screen can be changed WITHOUT PWE enabled (on). I just had a customer accidentally change one!

RRL

[ajm100a]

I tried it and they are already set to 0. This is a 0-tt control...on a Saginaw twin vertical lathe. The screen should show sv-prm for the soft button, but doesn't. Anything other than parameter 389??

[RRL]

If this is a "TT" you will need to do both sides Right and Left.

RRL