Neednig a basic or sometype of post to get started with. thanks for any help!
Results 1 to 3 of 3
-
11-04-2008, 01:34 PM #1
Registered
- Join Date
- Nov 2008
- Posts
- 1
NEED HELP-NX6 POST FOR OKUMA OSP-P100M CONTROL
-
11-08-2008, 05:27 AM #2
Registered
- Join Date
- Nov 2008
- Posts
- 12
Greetings
Please send me your details at this link and let's see if I can help you
http://www.icam.com/html/products/form_bw.php
PPDEV
-
11-11-2008, 02:56 PM #3
Registered
- Join Date
- Feb 2006
- Posts
- 146
NX post Library
On the GTAC support page http://support.ugs.com/
you can download from the Post Library
IN NX you can also select Help - Online Technical Support - Download NC Postprocessor.
You will need a webkey login - (You may need to set up your web key which is part of your NX license fee)
These are a good place to start then you can edit them with Post Builder.John Joyce -NC Programming Supervisor
Barnes Aerospace, Windsor CT
Reply With QuoteSimilar Threads
-
Fanuc 18T control on a Okuma Howa
By Dwayne Wismer in forum FanucReplies: 6Last Post: 11-08-2010, 05:34 PM -
Okuma OSP 2200 Control
By cnccontrols in forum OkumaReplies: 3Last Post: 01-28-2009, 12:02 AM -
Okuma retrofit Machmotion control
By KGD in forum OkumaReplies: 0Last Post: 04-23-2008, 04:45 AM -
Okuma & Howa Act 4x Control Fanuc O-TT-C
By Asesino in forum SpanishReplies: 0Last Post: 06-11-2007, 10:58 PM -
Okuma VAC-Motor feedback control?
By DennisCNC in forum Servo Motors / DrivesReplies: 1Last Post: 10-04-2006, 04:08 AM
Posting Permissions
