ver 22 verify not working in lathe mode.it works fine in mill mode,does anyone else have this problem and is there a fix for it?
thanks,
shawn
Results 1 to 3 of 3
-
08-28-2008, 07:47 PM #1
Registered
- Join Date
- Feb 2006
- Posts
- 15
version 22 verify not working in lathe mode
-
08-29-2008, 01:10 PM #2
Registered
- Join Date
- May 2008
- Posts
- 5
lathe verify not working in 3d. Once in verify, right click in window, go to properties, click on lathe, should change to 2d pic. should work from there.
-
08-29-2008, 01:54 PM #3
Registered
- Join Date
- Feb 2006
- Posts
- 15
Thanks for the reply,
I have tried what you suggested and i get the 2d view of the finished part,but whats not working is the 3d tool simulation(tool in motion) i have some very detailed part geometry and i would like to see the operation simulated.
--shawn
Reply With QuoteSimilar Threads
-
HAAS LATHE Graphics Simulation MODE
By DEAN in forum Haas LathesReplies: 4Last Post: 11-19-2007, 04:45 AM -
Mazak Integrex 100Y Subspindle Milling Mode not working
By mzbik in forum G-Code ProgramingReplies: 3Last Post: 01-22-2007, 07:59 PM -
Lathe for Glass Working
By ViperTX in forum Glass, Plastic and StoneReplies: 0Last Post: 12-12-2006, 07:16 AM -
VCarve Pro Trial version 3.0: any newer version?
By monte55 in forum VectricReplies: 2Last Post: 12-12-2006, 12:12 AM -
Lathe version
By cncman2 in forum Mach LatheReplies: 1Last Post: 04-27-2003, 05:59 PM
Posting Permissions
