586,121 active members*
3,463 visitors online*
Register for free
Login
IndustryArena Forum > CAM Software > Vectric > Yet another Cut3D 1/8" spiral saw cut...

Thread: Yet another Cut3D 1/8" spiral saw cut...

Results 1 to 2 of 2
  1. 09-20-2008, 08:35 AM #1
    bsimages
    bsimages is offline Registered
    Send a message via Yahoo to bsimages
    Join Date
    Sep 2005
    Posts
    116

    Smile Yet another Cut3D 1/8" spiral saw cut...

    Here is a Russian Madonna cut in Redwood with a 1/8" spiral saw bit.
    I gave it a light sanding and it was then spayed with clear lacquer with gold paint on the halos.
    Attached Thumbnails Attached Thumbnails MD.jpg   MDCl.jpg  
    Reply With Quote Reply With Quote
  2. 09-20-2008, 08:40 AM #2
    Khalid
    Khalid is offline Gold Member
    Join Date
    Apr 2006
    Posts
    3498
    hmm.. good work you are doing man..keep up posting
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. V18.0 Spiral Thread post has no "Z" Output
    By twt in forum BobCad-Cam
    Replies: 11
    Last Post: 09-10-2011, 02:58 AM
  2. Another Cut3D 1/8" spiral saw cut!
    By bsimages in forum Vectric
    Replies: 6
    Last Post: 09-01-2008, 11:11 PM
  3. Cut3D and a Spiral Saw Bit
    By bsimages in forum Vectric
    Replies: 2
    Last Post: 07-06-2008, 09:48 AM
  4. 3D DXF with Cut3D
    By Switcher in forum Vectric
    Replies: 4
    Last Post: 04-25-2008, 11:46 AM
  5. RFQ-Anodize qty:65 32" spiral staircase steps -Denver
    By douglasco in forum Employment Opportunity
    Replies: 0
    Last Post: 05-06-2007, 04:59 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules