208wye or 240delta
Hi Guys Hope you can help me decide on which voltage to supply to my shop.
I finally got a mori sl 15 for may shop and having a new 3phase system run into the shop, But what voltage is used to run most equip.
the Mori lathe is asking for 220 v
Bridgeport Mill 220/230v Hardinge lathe 220v ect,
So which voltage would be better?
208wye or 240 delta
Thanks for any info
IF ITS NOT BROKE YOUR NOT TRYING HARD ENOUGH
Ashes to ashes , dust to dust , If it wasnt for Harleys the fast lane would rust.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)