586,123 active members*
3,277 visitors online*
Register for free
Login

Thread: FANUC 15T Write Protect

Results 1 to 3 of 3
  1. 10-11-2008, 08:27 PM #1
    bmlw
    bmlw is offline Registered
    Join Date
    May 2006
    Posts
    54

    FANUC 15T Write Protect

    Hello, maybe some of you FANUC experts could shed some light. I have finaly gotten back to my machine and things were looking good for startup. I have run in to a new problem. When I try to modify the parameters so that I can use the serial port for program loading I get the write protect message. I have found thet I need to modify Parameter 8000 - PWE to 1 to clear the write protect but have been unable to do so. The manual says to go to the settings screen, enter 8000, press the input number soft key and the paramater should display on the screen. This does not happen. Any Ideas? I have gone into the Service screen and can see the Parameter but am not able to change it there either.

    Thanks in advance
    Reply With Quote Reply With Quote
  2. 10-11-2008, 08:32 PM #2
    Al_The_Man's Avatar
    Al_The_Man
    Al_The_Man is online now Community Moderator
    Join Date
    Dec 2003
    Posts
    24221
    Set mode to MDI.
    Soft key: Settings, Chapter, General
    go to P8000 push 1 enter.
    Al.
    CNC, Mechatronics Integration and Custom Machine Design

    “Logic will get you from A to B. Imagination will take you everywhere.”
    Albert E.
    Reply With Quote Reply With Quote
  3. 10-11-2008, 08:47 PM #3
    bmlw
    bmlw is offline Registered
    Join Date
    May 2006
    Posts
    54
    Thank a bunch. I will go and try it out right now
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Okuma howa tool geometry protect
    By chrisclegg in forum Okuma
    Replies: 0
    Last Post: 10-10-2008, 02:36 PM
  2. Parameter write enabling on Fanuc OiT
    By hense in forum Fanuc
    Replies: 6
    Last Post: 06-02-2008, 11:26 AM
  3. Anyone know where I can get a Program Protect key?
    By Billmac in forum Fanuc
    Replies: 11
    Last Post: 04-14-2008, 05:31 PM
  4. kingston cnc lathe data protect key
    By m.amir in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 0
    Last Post: 10-02-2007, 07:34 PM
  5. Protect your G54...G59
    By jorgehrr in forum Fanuc
    Replies: 3
    Last Post: 10-01-2007, 01:11 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules