I have experienced some strange things using my DSP.
Here is a list:
1: Z axis limit switch seems to work when going to Home, but some times using the manual Z axis movement on the DSP controller it don't stop. It's not a big thing, but if you don't use you're brain you could run the Z axis up to it knocks the axis to it's limits.
2: When the machine is turned on, but not used for a while (setting up the material to be milled etc) the DSP may turn in to a very "slow mode" where it is very slow on reacting on key-press on the keypad. When this happens, it can't find any files on the U-disk (USB memory stick) what ever I do. It's not related to the USB stick, since I have a different one to test out and both do not get recognized. The only thing to do is to turn the machine OFF and ON again where everything work fine.
3. Tonight I experienced another strange thing when I did clean down and lubricated the machine: It was not in use for a while, I was just jogging the axis to get the grease out on the rails and cleaned the spindle. After spindle clean the machine did not want to respond to any key press at all. It did not want to move in any directions whatever I tried. I had to turn it OFF and ON again and the machine then worked like normal.
Very frustrating and irritating since the machine has hardly been used and I can't see what should cause this to happen.
Any one with same experiences ?
Kent