[Bolle_Ma]

Hi

I just installed a 1981 yasda YPC 45 machining center. The machine is in mint condition.
Anyways here comes the problem.
When i fire up the machine everything seems fine. I do atc chek and table ready. I set the mode to MDI go to COMND move a page down, to start a block. I punch the desired code and press INPUT.
When it is done (and here`s the pickle) i press start and nothing happens.
I`ve tried everything i can think of i`ve turned the machine on and of sevral times. But sudenly this morning, when i turned the machine on it worked.
I used the machine for some time and turned it of.
When i some time later turned it back on again it`s same old same old.

That said i have no experience with fanuc controll what so ever.
So i might have got something wrong from the start. But i`ve read the user manual and can`t see that i have.

Anyhow any suggestion why this could be.

[Al_The_Man]

In MDI did you enter EOB end of Block?
Does the START light come on?
No end of Block, no START light.
If START light, then program is hung up on a command.
Al.

[Bolle_Ma]

Sorry to say Al either i din`t get when to press EOB or it didn`t work.
(The first reason is probably the best explanation.)
But since i didn`t press EOB in that glorious moment it actualy worked.
I suspect something else to be the reason.
I do suspect a slightly defect start button. But i also suspected every other button to be defect intill i knew how to use them

And you mentioned a start lamp i can`t really identify one.

PS: i added some screenshots. maybe some of you who has seen how the scrren shuld look like kan identify if you see something suspicious.

[Al_The_Man]

EOB is a button and a semi-colon is entered at the end of a line before ENTER.
Usually the MTB puts a light in the Cycle-Start P.B.
To test the buttons you can go to the diagnostic page and look at the inputs to see if one changes from 0 to 1 when pushed.
Al.

[Bolle_Ma]

Problem solved.
A wire for one of the safety buttons where eroded.