586,103 active members*
3,319 visitors online*
Register for free
Login

Thread: Mori SL-2

Results 1 to 3 of 3
  1. 10-20-2008, 07:16 PM #1
    JMECKES
    JMECKES is offline Registered
    Join Date
    Oct 2008
    Posts
    25

    Mori SL-2

    I have an old Mori SL-2 with a 3T Fanuc control. Powered it up this morning and found that the spindle would only go about 200rpm during warm-up. We had this problem before and it was a fuse. No such luck this time. Can anybody point me in a direction for diagnosis?
    Reply With Quote Reply With Quote
  2. 10-31-2008, 04:33 AM #2
    Daypass
    Daypass is offline Registered
    Join Date
    Sep 2006
    Posts
    7
    10/20 found the problem yet? need more info to help. Alarms? G50 cap on speed? noises?
    Reply With Quote Reply With Quote
  3. 10-31-2008, 01:06 PM #3
    JMECKES
    JMECKES is offline Registered
    Join Date
    Oct 2008
    Posts
    25
    We found a momentary voltage drop off on pin #1 on the drive board, but then it seemed to recover. Machine is now running. We have a meter on it to let us know if there is another voltage drop. There were no alarms probably due to the signal getting through and spindle start confirmed even though it didn't get to speed commanded. Had to find a break in the line when it is so intermittent. We'll just have to wait until it drops again.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. mori-seiki
    By ron2008 in forum Mori Seiki Mills
    Replies: 2
    Last Post: 10-08-2008, 09:22 PM
  2. MORI
    By Mori in forum G-Code Programing
    Replies: 7
    Last Post: 07-07-2008, 06:16 PM
  3. Mori or Hitachi
    By Paul in OK in forum Mori Seiki lathes
    Replies: 1
    Last Post: 03-12-2008, 08:00 PM
  4. Mori w/10T
    By grease in forum Fanuc
    Replies: 2
    Last Post: 10-26-2007, 11:10 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules