586,392 active members*
3,199 visitors online*
Register for free
Login

Thread: G01 Problem

Results 1 to 2 of 2
  1. 10-16-2008, 02:58 PM #1
    Harbor
    Harbor is offline Registered
    Join Date
    Oct 2008
    Posts
    3

    G01 Problem

    Hello,

    First Post here. I'm working on an older Hitachi wire EDM with a Fanuc control. We've run into a problem, it seems like it basically occured over night. When we try to dry run a program, programs that we have run in the past succesfully and that have not been altered to our knowledge, the machine stops moving at the G01 block. Does the same when the wire, water, edm power are on. Rapid is fine. No alarms. Any thoughts would be appreciated.

    Thanks,

    Harbor
    Reply With Quote Reply With Quote
  2. 10-16-2008, 09:03 PM #2
    Harbor
    Harbor is offline Registered
    Join Date
    Oct 2008
    Posts
    3

    Fix for G01 Problem

    Hello all,

    We did locate the problem on this machine, for those of you who are interested it was a corrosion issue on board i/0c3a16b12110300a, located in the front cabinet. Cleaned it with a pencil eraser and everythings works fine now.

    Harbor
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. machine problem or software problem?
    By bcnc in forum Syil Products
    Replies: 8
    Last Post: 10-26-2009, 03:51 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules