Anybody done this before? The X axis appears to be whipped. We had some plugged lube lines and it appears the linear guides are shot....lots of noise and the table jumps under medium cuts. The ballscrew seems fine with only .0003" -.0004" backlash. Ideas on cost and procedure?
Results 1 to 2 of 2
-
10-21-2008, 12:27 AM #1
Registered
- Join Date
- Jun 2008
- Posts
- 27
Linear guide replacement for 15xt
-
10-22-2008, 01:59 AM #2
Registered
- Join Date
- Feb 2008
- Posts
- 547
I have no help other than...
I think I recall the way set from Fadal is around 1800 bucks. I believe you may be able to buy from FadalCNC ( I think that is the name) or one of the other Fadal part houses cheaper.
I have a small rust spot on my 15XT that so far is not a problem, but may grow into one someday, so I'm interested in what you come up with.
Steve
Reply With QuoteSimilar Threads
-
Choise the right linear guide
By Cardedon in forum DIY CNC Router Table MachinesReplies: 3Last Post: 03-31-2008, 07:56 AM -
Guide wire linear motion
By AustinT in forum Linear and Rotary MotionReplies: 10Last Post: 08-15-2007, 02:36 AM -
Fuse And Linear Guide
By Alex S.A in forum Uncategorised MetalWorking MachinesReplies: 0Last Post: 03-18-2007, 11:48 PM -
Diameter of shaft for linear-guide
By Phantom in forum DIY CNC Router Table MachinesReplies: 7Last Post: 10-26-2005, 04:11 PM -
Support for linear guide
By wile_e in forum Mechanical Calculations/Engineering DesignReplies: 7Last Post: 01-30-2005, 12:30 AM
Posting Permissions
