I have built a 3d model and used Mastercam to generate an NC Code to be used in the Roland MDX 500 Mill. My question is how do I transfer this NC code to the MDX 500 to run the cutting sequences? This all started when I tried to do simple contour cuts which should have took 30 minutes instead took 12 hours when i introduced the part ( Iges format) to Modela software which sent the data to the 500 Mill as a whole cutting process...It would have been easier to just use an engraving software etc.. Please help i am at a loss to get this cut fast instead of having to wait 12 hours at a time...

Newbie sort of.....

Georgios