[CNCRim]

I worked with Mazak multitask before and I like it, but I don't have experience with other brand so I can't compare.

What's do and don't like, advantage and disvantage between these machine?

[the thrill]

The Mori NT rocks. Hands down.

The Mori offers special technology such as DCG, box-in-box construction and a lower turret with a direct drive milling motor (just look on their website about all of that). I've had experience with Mazaks for a number of years and while they are decent machines, they - like any other machine - have their share of issues. The Multus is similar to the mark series integrex - not the E series. It's a slant bed design instead of vertical bed. It really boils down to personal preference. The Mori uses a fanuc 30i series controller with a Mori designed interface laid over top of it. The Mazak uses mitsubishi drives with the mazak matrix controller and i'm not quite sure about the okuma. I think they use Siemens drives with their ThiNC controller.

It also depends on your local service. Some areas have better service than others... unless you have a DMG

[likestomachine]

I've worked with Mazak as well as Mori's. The Mori is the best ..Mazak service is HORRIBLE...