[apylus444]

Hello,
We just acquired a Hurco BMC30/D with Delta Dynapath control. Does anyone have PDF of manuals, or anything to download/view, etc.? Also, I see that COM 1 is set for 9 pins. Does a special cable have to be built for loading programs or is that set for a standard 9 pin cable? Much thanks,
apylus

[LuisG]

Recently I bought an used Vertical Machining Center Hurco BMC 30/D (year 1995).
Unfortunately the machine comes without any manual, or hand book.
I contacted Hurco and they sent me a PDF called "PART LISTINGS & WIRING MANUALS for the Hurco Bedmill Machining Centers". I can send this PDF to you if you don't have it yet.

If you have something about the Dynapath Delta CNC Control I appreciate if you could send it to me.

Regards,

Luis Garcia
[email protected]

[pocok]

Hello LuisG,

I'm looking for the same manuals. Please send me if you can
My email is: [email protected]

Thanks,

Joe

[Brock_r]

What Model Dynapath Control is on your Hurco 30D ?

The early one was a Delta 10/20 Serial No's began with 1

After 1995/96 it was a Delta 40/50/60 Series

Is the computer card rack a Silver Box ? If so it is a Delta 40/50/60 Series, Serial Numbers began with a 2

Let me know and I'll see what I can dig out of the closet