NSK Servo voltage and control requiremnts
Hi,
I picked up 2 ballscrews off eBay with 2 undescribed motors attached. I planed on just using the ballscrews and discarding the motors and attaching them to some steppers I have.
After looking at them I'm considering using the servo's that are already attached. It looks to me the motors are NSK either 1006's or 1012's, probably the 1006.
http://www.us.nsk.com/library/catalo...S%20MOTORS.PDF
A quick search of the NSK site didn't show what voltages, current requirements and pinouts. I can figure out the encoders but don't have a clue about the servos.
My questions are:
1. Can I buy a couple of gecko drivers and hook them up with Mach3 or do they need proprietary drivers/controllers?
2. What is the power supply requirements for these. Note: the 1006's are230VA and the 1012's are 380VA?
3. Should I just discard them and use the steppers I had planned on using anyway.
Any help or thoughts would be appreciated.
Bob
GO-Tech: Geek Show&Tell Meets Ann Arbor 2nd Tues at www.maker-works.com
South East MI cnc meets 1st Wed at www.maker-works.com