We are looking for help to renovate/ re start old AGIE puls EDM & MA400 wire edm with fast track & cnc100 control. Please let us have some information.
We have bought it from e bay & wish to use it for hobby applications.
We are looking for help to renovate/ re start old AGIE puls EDM & MA400 wire edm with fast track & cnc100 control. Please let us have some information.
We have bought it from e bay & wish to use it for hobby applications.
We have 4 Agie wire cuts with CNC 100 controlers, what information do you need?
Colin
Dear Sir,
I neeed the wiring diagram, maintenance manual, & instructions on how to start/use the machine. The deionizing bottle is missing. Thus I will need the bottle along with the copies of the available technical manuals. We are ready to pay for the help.
Regards
S D Kulkarni
Hi, I have serviced these machines since 1980. I have all the manuals for them (Service and application) These manuals do not have the Electronic schematic drawings in them.
Dear SIr,
We will be glad to receive a copy of the manual on chargeable basis. The machine panel is disconnected from thr machine body. Thus interwiring detalis are very moch necessary to start the complete equipment. Any help in the matter will be appreciated.
Regards
S D Kulkarni
hi y have AGIECUT 100 from 1981 and y have problem with 2 board in cnc 100 controler that boards give a signal to display but y don t have a electric documet of that 2 board if anyone know please let write .....
I have a sinking edm AGIE, Switzerland.Type: BF-h (Servo Hydraulic), these are very straight forward scheme compared to wire edm of similar date. It is regular transistorized plus RC type generator & error signal circuitary. I have traced a part of it on my own & have started it long back. I think you also can follow similar procedure.
I am trying. I have removed the control panel and am tracing the wiring. In the Control Panel Relays K800, K801, and K802 must be made for Gap Power. But only K801 is coming on by itself. When K800 is mechanically made the "Setting Check light" on the Generator goes out and the Gap power will come on. But then K802 must also be touched to latch in the Servo control from the Generator.
Thanks for replying. Just wondered if anyone had the schematics for the Tool so I don't have to hunt and peck.
TROU
Where can one get these Electrical Schematics?
Agie looked after their Schematics like gold, but like gold a few slipped through. We have the manuals that came with the machines and a few extras we have gathered over the years. For us it is still a pull and exchange cards fault finding process, but then we have a few of the same machines. Once traced to the card, without the schematics, it is still often impossible to fix. For us then we have 2 choices, send the card to Techstar in USA, where often a guaranteed replacement or repair can be organised. Otherwise take your chance with a board from Ebay, Amazon, etc. Even then, there are differences in the boards, for the same system. Sometimes they work straight away, sometimes they need tweeking with your old board parts. Best of luck, Colin
I am looking for parts for this very EDM Agie Puls. We are located in the US. Does anyone have the control / display for sale?