Does anyone know where to obtain the post processor for a Haas tl1 for mastercam x2? We have a TL-1 standing dormant at my university for the past 2 years because no one knows how to use it!! Any help would be greatly appreciated. Thanks!
Does anyone know where to obtain the post processor for a Haas tl1 for mastercam x2? We have a TL-1 standing dormant at my university for the past 2 years because no one knows how to use it!! Any help would be greatly appreciated. Thanks!
Sir, the Haas TL1 comes with the Intuitive Programming System in the control, it's easy to use and you will be up and running immidiately without the need for a CAM system.
The best place to get the Mastercam post is from Mastercam.
Thank You,
Gerard Bailey
Applications Engineer
Haas Automation Inc
Tel. 800 331 6746 x7128
[email protected]
You mean that in two years no-one has had the initiative to get hold of the manual for the machine, or download a copy from the Haas website or download some of the Haas training material and figure out how the run the machine? That is abyssmal; I was under the impression that people went to university to learn advanced knowledge and to think for themselves. Do you have nurse running around after you to wipe your nose when it dribbles?
An open mind is a virtue...so long as all the common sense has not leaked out.