I am in the process of making my own digitizing probe like this one http://www.vinland.com/Touch-Probe.html and was wondering how you physically hook this to the mill.I am using a tm3.Once i get this hooked up what do i need as far as software to digitize on the haas.Any help or links would be greatly appreciated thanks.
Thread: how to hook probe to tm3 mill
Results 1 to 3 of 3
-
11-20-2008, 11:24 PM #1
Registered
- Join Date
- Jul 2007
- Posts
- 10
how to hook probe to tm3 mill
-
11-21-2008, 07:26 AM #2
Registered
- Join Date
- Jul 2005
- Posts
- 340
On the IO board , left side , around middle in heigth search for a P33 ( when I am not wrong or P31 ) SKIP plug , that is what you need.
-
11-21-2008, 02:50 PM #3
Registered
- Join Date
- Jul 2007
- Posts
- 10
I found a 4 prong plug on the board that is marked p3 90 amp and says probe beside it so i'll assume it goes there but does anyone know how the probe should be wired? the plug has two d shapes and two square shapes.once i get this probe wired does anyone know if the haas comes with the software to be able to digitize?
Reply With QuoteSimilar Threads
-
Super Probe 17 Functions in one probe
By thegimpster in forum PIC Programing / DesignReplies: 0Last Post: 01-25-2008, 07:46 PM -
Where does encoders hook up?
By jimluu in forum Stepper Motors / DrivesReplies: 2Last Post: 05-20-2007, 03:15 AM -
Drive has CW/CCW, need to hook to LPT
By foam27 in forum Stepper Motors / DrivesReplies: 5Last Post: 05-20-2007, 02:25 AM -
fanuc 3m on hook up to pc
By Gpestarters in forum FanucReplies: 6Last Post: 07-27-2006, 03:31 PM -
C Hook
By Graphcon in forum MastercamReplies: 5Last Post: 01-11-2005, 08:06 PM
Posting Permissions
