Hey all,
Not sure if I'm posting in the right section or not.
I'm trying to get this lathe running that I've been tripping over for about 8 years LOL.
I powered her up and I'm getting alarm 28 and the tool turret just starts spinning.
I design & build automation machinery for a living and retrofitted an old Bridgeport Series 1 with an Ajax controller ... was hoping I wouldn't have to go thru that with this lathe and/or scrap it ... been holding onto it forever and finally have the time to try and get her running.
Any input advice greatly appreciated!
I have the controller manual and a manual for a Mori Seiki with the same controller but no wiring schematics or info about this "machine not ready" alarm 28.
Give me the bad news if that's all there is on these older machines.
Thanks all,
Sean