The m/c is a colchester tornado 200 and does not have a swrf conveyor fitted, is there a way of turning this message off?
Thanks,
Gareth.
The m/c is a colchester tornado 200 and does not have a swrf conveyor fitted, is there a way of turning this message off?
Thanks,
Gareth.
I don't know the machine, but it is posted in the Fanuc forum so I assume it has a Fanuc controller.
Rather than change the ladder, you could find the input that confirms the conveyor is started and place a jumper on that input, if you have the ladder diagram, it may show it.
It is probably intended to monitor a N.O. contact on a motor contactor for e.g.
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
just call clausing they are very good about helping your repair machines ask for mike in services they open at 8am eastern time
Phone (269) 345-7155