do you have to enable fro not rapid but straight fro in mach3 the f10 and f11 button only change the dro but not the actual speed i did a quick search in the forum but all i found where people asking about rapid fro.
do you have to enable fro not rapid but straight fro in mach3 the f10 and f11 button only change the dro but not the actual speed i did a quick search in the forum but all i found where people asking about rapid fro.
The opinions expressed in this post are my own. -Les opinions exprimé dans ce messages sont les mienne
What version are you using? It works in 2.63 and 3.42.020, although it seems to work a little quicker in 2.63. Do you have the box checked to lock them together in General config?
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
ok so if its check then fro wont go over 100% because rapid fro is allready at 100% is that it
3.42.020
editk thats kinda weird i have uncheck the lock between the rfro and the fro now it work but in order for it to work i have to do a feed hold and cycle start again
edit2: ok unchecking the feed queu something solved the problem finally i am close to getting a machine that operates properly
The opinions expressed in this post are my own. -Les opinions exprimé dans ce messages sont les mienne