When we power up our Fadal VMC15, it dose a cold start ok but then when we try to move an axis in MDI we get the error message “failure setting servo gain”. We can move all three axis in hand wheel mode. I can’t find anything on this in the manuals. It is a 1994 machine, 88HS, DC servos.
Thread: Failure setting servo gain
Results 1 to 3 of 3
-
12-10-2008, 02:42 AM #1
Registered
- Join Date
- Dec 2004
- Posts
- 167
Failure setting servo gain
-
12-10-2008, 08:10 PM #2
Registered
- Join Date
- Mar 2003
- Posts
- 900
This would normally be either a corrupt survey or a bad controller card.
Neal
-
12-10-2008, 08:46 PM #3
Registered
- Join Date
- Dec 2004
- Posts
- 167
Neal,
Thanks for the reply, how can I narrow down my problem?
Reply With QuoteSimilar Threads
-
Fadal... Failure setting servo gain
By ssking in forum FadalReplies: 5Last Post: 07-10-2008, 09:19 PM -
Smoke and cascading failure with servo, G320
By leo.dearden in forum Gecko DrivesReplies: 5Last Post: 02-23-2008, 02:04 AM -
setting up servo drives
By planeflier in forum Servo Motors / DrivesReplies: 17Last Post: 01-07-2007, 07:34 PM -
Haas VF-3 servo distribution power supply failure
By Drkk in forum Haas MillsReplies: 0Last Post: 12-04-2006, 04:48 AM -
Servo motor specs. and driver setting questions.
By southernexplore in forum Servo Motors / DrivesReplies: 1Last Post: 08-04-2006, 01:21 PM
Posting Permissions
