Originally Posted by
nelZ
I have Bobcad 19 & 22. One machine is Camsoft but I didn't have the 5000$ for the Pro disk.
Do I have to spend 3000$ more just to get a good peck drill cycle or can I make Bobcad just output each individual move?
Camsoft has G83 but no chipbreak cycle so I'm cutting a ton of air and it's really annoying.(nuts)
Thanks in any event!:rainfro:
Nelson
My cam software doesn't do g83 either. I just let it give me a g81 and hand code the correction to do a g83. Same goes for the chip breaking cycly.I figure it cost me about a dollar to do each one. That is 3000 edits to break even. I think I will do it by hand.
Warning: DIY CNC may cause extreme hair loss due to you pulling your hair out.