I looked through the forums but I still cannot figure this out...
I am trying to make some desk name plaques. They are made of aluminum and each one will have a name engraved into them. I have my area set up where I want the letters to go and I even have the letters typed in, but I cannot get them recognized by DolphinCad as a Contour (I think that is what I want). I clicked on text gallery and picked a "Stroke Font", but I cannot do anything with it. When I go to the CAM all that is brought up is my original rectangular drawing with nothing on it.
What am I doing wrong? I have Level 2 if that makes any difference.
Mike