Hello guys,
I have Hitachi seiki hs500. In machine right now I can see only 3 axis (xyz) in controller. But 4th b axis module as well as motor also mounted in machine.
Can any one help me how to enable 4th axis in hitachi seiki hs500?
Hello guys,
I have Hitachi seiki hs500. In machine right now I can see only 3 axis (xyz) in controller. But 4th b axis module as well as motor also mounted in machine.
Can any one help me how to enable 4th axis in hitachi seiki hs500?
Hello
did you get this sorted - its an easy fix but not very upfront - let me know and Ill help you out!
John
Hi, can you send me the procedure to reset the turret of a TS15 seicos 21L
[email protected]
Hai There,
We are facing Hitachi seiki C Axis alarm, any way we are not using that axis so if you have C axis Bypass parameter kindly send me [email protected]
Hai Hitachi Man
We have HS CS 25 Machine with SEICOS 21L, Now we faced C axis Problem but we are not using that C axis(Spindle act as a C axis). I request you to kindly send me the procedure for C axis By pass.
My mail id is [email protected]
Thanks in Advance.
Hai All,
Kindly support me.
OEM : Hitachiseiki
NC: SEICOS 21 L
Required: C axis By pass Parameter.
(Spindle act as a C axis)
My mail id: [email protected]
Any service available for Hcut 203 EDM?
I have a hitachi seiki Hicell CA20. Great little machine. Tonight I had a live tool dismount from the turret whilst cutting, probably went blunt and too much side load. Anyway, now the turret live tooling coupling is misaligned. it engages / disengages fine. just not where it should be to load and unload the tools wit ATC. It's like it's jumped a tooth or 2 on the belt. I have never seen this before, so not sure where to look. Books have zero info on this. I can only assume there is a proximity switch somewhere with a dog to locate the orient for engaging. Any help appreciated.
Hey guy! Do you have HS500? you can send for me sram backup file and system data save file
My email: [email protected]
Thanks
Hi Hitachi Seiki_Man
My name is Michal I'm from Poland.
I have a Hitachi Seiki HT20R. The problem is with the main motor yaskawa drive. There are no errors after the machine is started and referenced. When I try to set RPM in YOG mode, the load meter goes to 110% on the Yaskawa panel, the RUN indicator lights up but the engine is stopped. Can you somehow help ??
Best regards Michał
pudiste comunicarte con jhon?
necesito ayuda o soporte tengo un VA - 45 errores led en placa C mayuscula / c minuscula / F mayuscula si podes ayudarme seria genial
Send me a pic of the alarm, sounds like you are saying its CcF?
I have a Hitachi Lathe HT 20RIII with a Seicos Multi control throwing a flash Error intermittently upon start up. Seems to be getting worse every day. I can usually reboot it a few time and it will start. Any suggestions I cant find anyone that seems to know these machines anymore.
Ryan
Hello Ryan
Send me a PM with your email and I’ll help you out
Sent from my iPhone using Tapatalk
Hello,
I need the eletric scheme of Hitachi Seiki TF25 – Seicos A10L...
In fact i just need the electric scheme of the RS232C terminal to exchange data. Does anyone have it?
Thnak you so much in advence.
Marisol Delgado.