i need electric drawing hitachi seiki va 45 fanuc 11m can you help me
i need electric drawing hitachi seiki va 45 fanuc 11m can you help me
Hi,
I have 1986-87 Hitachi-Seiki HT-20 Fanuc 10TE control cnc lathe. It was setting for a couple of months. went to hook it up and it boots up to ram test then stops and goes no further.... any suggestions?
Jim Compton
Visit www.manuals-depot.com Many tractor manuals available
Hi Jim
you might need to regen if it lost battery / data - you can pm me your email and Ill reach out to get you going
John
I have a hitachi seiki Hicell CA20. Great little machine. Tonight I had a live tool dismount from the turret whilst cutting, probably went blunt and too much side load. Anyway, now the turret live tooling coupling is misaligned. it engages / disengages fine. just not where it should be to load and unload the tools wit ATC. It's like it's jumped a tooth or 2 on the belt. I have never seen this before, so not sure where to look. Books have zero info on this. I can only assume there is a proximity switch somewhere with a dog to locate the orient for engaging. Any help appreciated.
Any service available for Hcut 203 EDM?
Hi Josh, I have an HT23J. The tool unclamp/clamp piston hit the hydraulic tool release piston while the turret was indexing, & stopped the turret. I don’t know how to get it back to zero. Can you help me with the procedure to zero it?
Its a Hitachi-Seiki HT23J with a Yasnak control.
Thank you
Mike
[email protected]
Dear friends,
How to set zero return procedure on Hitachi Seiki VM 40II,seicos 3?
Thank You,Have a nice day
Rizal
Hello
what do you mean? Did you lose data and now it is not going home but oevertravelling?
After SPHC card has changed,now the machine always overtravell when zero return performed
Thanks for your attention Mr John
Hi All
I have hitachi seiki st200, Seicos Pcflexi control.
Alarm 700044 EMG-STOP pressed. DB2. DBX185.4
Su--
Hi Hitachi_man
I have hitachi seiki vk45 vmc Ladder corrupted,No pack up and no YU YU software can you please help me
Thanks
Hi
I have hitachi seiki vk45 vmc Ladder corrupted,No pack up and no YU YU software can you please help me
Thanks
I have just got a old Hitachi VM40 with siecos mark II controller. When i power up the machine, i got alarm "battery alarm ---- please change", i change the battery when machine power up, but i can reset this alarm. Can someone help me???
Hello
did you get this sorted - its an easy fix but not very upfront - let me know and Ill help you out!
John
necesito ayuda o soporte tengo un VA - 45 errores led en placa C mayuscula / c minuscula / F mayuscula si podes ayudarme seria genial