We have a Kao Ming KMC4000SD Bridge Mill. The tool changer does not operate under automatic mode, however, all functions operate manually. Single blocking the tool change macro reveals that it fails just as the tool twin arm starts to move to the down position.
We have examined the macro and it is correct. The M06 LED remains on and the T LED remains off. We have verified the actuation of all hydraulics and sensors. The M06 command will cycle with a T0 selected as a tool but it will not run as T1 or if any other number of tool is selected. Does anyone know about how tool count parameters might affect this machine?
Results 1 to 2 of 2
-
01-14-2009, 10:14 PM #1
Registered
- Join Date
- Jan 2009
- Posts
- 2
Kao Ming Tool Changer w/Fanuc OMC Control
-
01-15-2009, 12:14 AM #2
Member
- Join Date
- Apr 2006
- Posts
- 213
I would check the prox switch for the tool arm up and down, sounds like one is not going off
Reply With QuoteSimilar Threads
-
Hoss 16 Tool Automatic Tool Changer
By hoss2006 in forum Benchtop MachinesReplies: 316Last Post: 03-03-2011, 10:29 PM -
tool changer
By machinist guy in forum Uncategorised MetalWorking MachinesReplies: 0Last Post: 07-14-2008, 10:03 PM -
Tool Changer picks up wrong Tool?
By KJ45 in forum Uncategorised MetalWorking MachinesReplies: 6Last Post: 03-13-2008, 12:51 PM -
VF-2 Tool changer
By hutch07 in forum Haas MillsReplies: 4Last Post: 09-05-2007, 01:52 AM
Posting Permissions
