Hello,
Do any of you know what settings I should use in EMC to drive CNC4PC's Speed Controller card?
I can only seem to get a constant voltage out of it; variable with the adjustment pot, but mostly around 4.48v.
I can see the pwmgen.0.value changing with the HAL meter, but I'm getting no obvious results.
Results 1 to 7 of 7
Threaded View
-
01-31-2009, 11:14 PM #1
Registered
- Join Date
- Mar 2006
- Posts
- 474
CNC4PC C6 Speed Controller setup?
Reply With QuoteSimilar Threads
-
CNC4PC Variable Speed Control Board
By Bubba in forum CNC (Mill / Lathe) Control Software (NC)Replies: 10Last Post: 08-07-2009, 04:01 PM -
Anyone had success with CNC4PC Speed controller on SX3?
By cjdavis618 in forum Benchtop MachinesReplies: 3Last Post: 03-21-2008, 03:08 AM -
CNC4PC C10 Breakout Board and C6 Speed Controller ? dont want to fry it
By maxboostbusa in forum Benchtop MachinesReplies: 2Last Post: 01-24-2008, 11:33 PM -
Xylotex and CNC4PC setup with mach3
By bruno123 in forum XylotexReplies: 3Last Post: 05-03-2007, 06:08 AM
Posting Permissions
