I have looked through too many catalogs now.
I have found a few low cost products that seem
to have very good quality.
GS Tooling , Techniks , & Maritool
I would appreciate and input/recommendations.
Thanks
Reply With Quote
I have looked through too many catalogs now.
I have found a few low cost products that seem
to have very good quality.
GS Tooling , Techniks , & Maritool
I would appreciate and input/recommendations.
Thanks
Reply With Quote
Bison and Lyndex are good too.
Bison is likely the most budget minded of the lot.
GS has the advantage of being 20,000 RPM certified, but you pay a little more for it.
www.integratedmechanical.ca
I just purchased a set of MariTool end mill holders and an ER20 collet chuck.
To say the least I'm very impressed with the quality.
The cost was lower than a number of competitors and the service was top notch.
A winning combination in my eyes.
The website was really easy to navigate too.
Timothy
Thanks