I do not know how much has been fixed. All I know is it still cannot produce a simple skin without flipping some of the skin into another plane. WTF is up with that? It's pretty tough to coax somebody how to do it right, when there is no right
I do not know how much has been fixed. All I know is it still cannot produce a simple skin without flipping some of the skin into another plane. WTF is up with that? It's pretty tough to coax somebody how to do it right, when there is no right
First you get good, then you get fast. Then grouchiness sets in.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
It certainly seems that the new patch has raised more issues than it settled.
You might want to stay with the previous patch, which I think you can still pick up in the Bobcad downloads area, in case you didn't back up your bobcad32.exe before you patched.
I still think the best patch for Bobcad is called ********
First you get good, then you get fast. Then grouchiness sets in.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
OUCH