[LuisSmith]

Good morning, I have a problem with a Fanuc 18i-tb control.

The lathe has a tool change by servo motor (A), the servo motor was changed for a new one and it asked me to make a reference, every time I want to use the servo motor it tells me "reference return incomplete"


https://www.youtube.com/shorts/q6fQDrznQEA

[cncmakers001]

Good morning, I have a problem with a Fanuc 18i-tb control.

The lathe has a tool change by servo motor (A), the servo motor was changed for a new one and it asked me to make a reference, every time I want to use the servo motor it tells me "reference return incomplete"


https://www.youtube.com/shorts/q6fQDrznQEA

The reference position return cannot be performed normally because the reference position return start point is too close to the reference position or the speed is too slow. Separate the start point far enough from the reference position, or specify a sufficiently fast speed for reference position return. Check the program contents.

[LuisSmith]

I add another video on YouTube, to see if you can support me

https://www.youtube.com/watch?v=SJz5ABlHoyY