Hi ,
I am new here and look forward to all the valuable information everyone has here , as well as helping out where i can but i am new to cnc milling we are running a Mikron VCP 600 and would like to hard mill dies , are there any tricks that anyone can shre with me as far as using mist as opposed to flooding the cutter with Crystal cut fluid ? What would be better than PCD cutters for hard milling also ? We are milling a part that is about 3/4 dia. and about .050 deep with no detail . Cutters we will be using will not go smaller than .062 dia. all ball end mills . Thanks for your time !!!
Dave