[saturnnights]

Hi,
I found the OneCNC $500 off coupon in my inbox this morning. That makes me wonder just how expensive this is anyway? I realize there are probably different levels/prices, but for 3-axis with waterline and spiral toolpaths, what did you guys pay for this? If I write them for pricing, they'll likely call me twice a week for the next month (like some others I've had to deal with).

Anywho, how much is this?

Thanks!
Mark

[nervis1]

For pricing you have to contact the company. For what you are looking for under 5k, maybe under 4k, I had the pro version for a bit, can't remember how much I paid for it though, that was 2003. I upgraded several times after that.

They will not call you twice a week, fact they won't call you at all unless you ask for a call back. They don't operate like that.

[saturnnights]

Thanks for the info. Honestly, that's a little too much $ for my pocketbook - that's why I was hoping somebody here could cool my jets before I bothered to contact the company

Thanks!
Mark

[nervis1]

Well know that the pro version is one step from their flagship version 3 axis software. They have (last I looked) 4 versions, cheapest is under 2k I think. Even if you are not ready to buy they will not mind at all if you call just to get info (more accurate than I can give). I promise they won't call you day and night

[Dan B]

Yes, I contacted them a while ago, and they have not made a single call back since (3 or 4 months). I did get a OneCNC newsletter in my inbox a week or so ago, but I don't mind that.

Dan